STEP 2: Ensure surface is already clean and dry. Use the Cleaner & Primer spray to degrease and deep-clean the surface thoroughly. It is recommended that the area to be treated is split into 0.25m² sections and sprayed evenly with 16 pumps (per 0.25m²) of the spray to ensure the best coverage. Polish-in the liquid with one of the wipes until the surface is completely evenly covered. Any residual liquid will evaporate in approximately 5 minutes at normal room temperature, leaving the polymer base layer. Only in the case of extreme contamination (or limescale) should a pre-cleaner for a specific type of contamination be used before the Cleaner & Primer spray is applied. NanoGuard X Step 1 Surface Prep Antimicrobial Surface Protection Coatings NanoGuard X Step 2 Surface Guard Antimicrobial Surface Protection Coatings
STEP 2: Apply the Coating spray to the pre-treated area, again splitting into areas of 0.25m² and using 16 pumps per section, polish with a new wipe as in Step 1 to achieve an even finish. Note: Any sediment visible in the bottom of the coating bottle is a natural occurrence – shake before use.
STEP 3: After 2 mins the surface should be buffed using the same wipe as in Step 2 until all visible streaks disappear, to leave a polished surface. After 6 hours the coating is hardened and ready for use. Wipe clean routinely and if necessary, use a non-abrasive household surface cleaner with a pH of between 4-9; do not use ‘spray and leave’ cleaners, so to avoid a residue on the surface.
Reapply after 12 months in heavily cleaned or abraded areas.